Homa Installing Profile Seals up to 6 inch Instrukcja Użytkownika Pobierz pdf

Publication

88LM2035

Please Contact Technical Support At 203-736-8890 With Any Additional Questions

Please Be Prepared To Provide Pump Serial Number During Call

Page

1 of 1

Installing Profile Seals

When installing a profile seal, one side of the seal has a larger diameter ridge on the outside

edge. This side goes to the inside of the guide claw as seen below.

Press the seal into its seat starting on one side and work the rest of the seal into the same

position. When finished, it should look as below.

When properly installed, the profile seal will stay in place when pulled straight outwards.

It is recommended that 3M Weather Stripping be applied to the surface touching the

claw if possible for added adhesion.

REMEMBER: the larger diameter always goes to the inside.

Publication 88LM2035 Please Contact Technical Support At 203-736-8890 With Any Additional Questions Please Be Prepared To Provide Pump Serial Number

Brak uwag

Homa Installing Profile Seals up to 6 inch Instrukcja Użytkownika